Sony DVO-1000MD Connecting External Equipment (2), Audio output selection, Input signal selection, •Audio output selection, •Input signal selection

Overview

Connecting External Equipment (2)

This section gives an example to connect external equipment for controlling the unit from connected external equipment

Settings required for using this connection example

Make the following settings before operating in this connection example using SETUP MENU.

For detailed information on menu operation, see “Basic Menu Operations” on page 50.

•Audio output selection

Select the audio output channel using the AUDIO MON CH sub menu of SETUP MENU (see page 47).

– LCH: Outputs the audio signal of audio channel 1.

–RCH: Outputs the audio signal of audio channel 2.

–MIX: Outputs a mixed audio signal from both channel 1 and channel 2. (factory setting)

•Input signal selection

Select the input signal “ANALOG” using the INPUT SELECT sub menu of SETUP MENU (see page 24).

•Remote control mode selection

Select an interface to control the unit from among RS232C (factory setting), USB and iLINK (see page 20).

When controlling the unit, only one interface is available from among RS232C (factory setting), USB and iLINK.

1 5

S-video cable (not supplied)DV cable (not supplied)

2	6
		USB cable (not supplied)
Audio cable (not supplied)	7
3		AC power cable (not supplied)
Audio cable (not supplied)
4
			Video monitor
RS-232C cable (cross type/not supplied)
	To S-video input connector			To analog audio input connector
		1
S-VIDEO IN	AUDIO IN L/R
				2
			1	3
		S-VIDEO OUT		To analog audio	To S-video
				output connector	output connector
		MONITOR AUDIO
7
to AC outlet - AC IN					External equipment
REMOTE IN RS-232C		4	to RS-232C connector
DV IN (i.LINK)		5		to DV connector
USB		6		to USB connector

Note

You can use only one interface from among RS-232C, USB and iLINK interfaces to control the unit remotely.

14 Connection