The REPEAT A-B display appears.

5 Select “A-B SET” by pressing the v button.

6 Press the SET button.

Playback starts, and “A” is displayed as a white letter at the bottom left of the screen.

“A” is highlighted in white.

7 Press the SET button at the instant when the picture comes to the point you want to set that as point A.

Point A is set and “A” disappears. Then, “B” is displayed as a white letter.

“A” disappears, and “B” is highlighted in white.

If you return to the previous menu display by pressing the B button after setting only point A

The point A set is cancelled. The points A and B previously set are retained. If you press the b button again, you can start setting the point B.

8 Press the SET button at the instant when the picture

comes to the point you want to set as point B.

The point B is set and “B” disappears. The repeat playback starts between the points A and B set. Those points A and B are stored until you set new points A and B or until the disc is unloaded.

Note

When erasing a title (see page 44) or formatting a disc (see page 33), points A and B set are cleared.

Stopping repeat playback between points A and B

The following two methods are available to stop repeat playback between two points.

•Using the B, b, .PREV/UP, or >NEXT/ DOWN button

•Using a menu operation

To stop repeat playback using the B, b,

.PREV/UP, or >NEXT/DOWN button Jump to a title or a chapter located outside of the section specified by the A and B points using the B, b,

.PREV/UP, or >NEXT/DOWN button.

To stop repeat playback by menu operations

1 Follow the procedure in steps 1 to 2 described in “Repeat Playback Between Two Points (A-B Repeat)” on page 36 to display the REPEAT FUNCTION item.

Playback

Repeat Playback 37