Load a disc on which indexes are recorded. Set the unit in stop or playback mode.

Miscellaneous

6REC button

Outputs the REC command.

7PAUSE button

Outputs the PAUSE command.

When the unit receives this command during playback, it pauses playback.

When the unit receives this command during recording, it pauses recording.

8F FWD button

Has the same function as the >NEXT/DOWN button of the unit.

9PLAY button

Outputs the PLAY command.

0REW button

Has the same function as the .PREV/UP button of the unit.

qa JOG/SHUTTLE button

To play back in jog/shuttle mode using the jog/ shuttle dial, press this button. The indicator lights up.

qs JOG/SHUTTLE dial

The playback direction and speed are determined according to the position of the shuttle dial, and the search command is output.

The jog dial becomes effective when the shuttle dial is set to the STILL position.

The playback speed and direction are determined according to the direction in which the dial is turned and the speed, and the search command is output.

Marking Indexes

You can mark indexes at the desired point during recording and playback.

1 Set the unit in the recording or playback mode.

2 Press the MARK button at the instant when the image to which the index is to be put is displayed.

You can mark up to 99 indexes in one title and up to 254 indexes on one disc.

3 Press the INDEX button on the remote control unit one time.

The INDEX command is sent and the unit is put in the index scan mode.

4 To search for an image located before the current position, press the REW button.

To search for an image located after the current position, press the F FWD button.

When the unit detects an index signal, the unit plays back the image recorded at that point for about 10 seconds, and then searches for the next index signal.

The unit searches for the index signals repeatedly up to the beginning or end of the disc.

To cancel the index scan mode

The index scan mode is automatically cancelled when the unit searches as far as the beginning or end of the disc. To cancel the index scan mode before reaching the beginning or end of the disc, press any one among STOP button, PLAY button,B and b buttons of the unit and the SVRM-100.

Cuing a Particular Image by Specifying an Index Number - Index Search

1

2

3 Press the INDEX button on the remote control unit twice.

The unit enters in the index search mode.

4 Specify the desired index number by pressing the INDEX button on the control unit the number of times that corresponds to the number of the desired index.

5 To search for an image located before the current position, press the REW button.

To search for an image located after the current position, press the F FWD button.

Searching for a Particular Image - Index Scanning

1 Load a disc on which indexes are recorded.

2 Set the unit in stop mode or playback mode.

Erasing an Index

You can ease indexes marked by pressing the MARK button of the SVRM-100A remote control unit. Proceed as follows to erase an index.

58 Using an SVRM-100A Remote Control Unit (Not Supplied)