3 Turn the Jog dial to highlight the item to be set and turn the Shuttle dial clockwise to finalize your selection.
The current setting on the selected line flashes.
4 Turn the Jog dial to change to the desired setting and turn the Shuttle dial clockwise to register the new setting.
When you set REC CYCLE for ALARM RECORDING, the number of alarm events that can be recorded is automatically calculated according to the PICTURE QUALITY setting and the available alarm recording area size and displayed in parentheses on the third line from the bottom.
Note
As long as the normal recording area has been established on the hard disk, the recording cycle for
5 When you use the
6 When the settings on the ALARM REC MODE SET display are completed, press the EXIT/OSD button to exit the menu
Setting the activity detection sensor
When you use the
Highlight ACTIVITY SENSOR and turn the Shuttle dial clockwise to enter Sensor Set mode.
The sensor marks are displayed on a 10 ⋅ 8 grid on the monitor, and the top left mark flashes.
- | - | - | - | - | - | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
|
| LEVEL | : 1 |
|
| EXIT |
|
| |
|
|
|
|
|
|
|
|
|
|
To turn on the sensor at a point
Turn the Jog dial so that the mark at the point where you wish to activate the sensor flashes, and turn the Shuttle dial clockwise so that the flashing mark changes to x.
Set the marks at all the points where you wish to activate the sensor to xin the same manner.
Example:
- | - | - | - | - | - | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
- | - | - | x | x | x | - | - | - | - |
- | - | - | x | x | x | - | - | - | - |
- | - | - | x | x | x | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
- | - | - | - | - | - | - | - | - | - |
|
| LEVEL | : | 1 |
| EXIT |
|
| |
|
|
|
|
|
|
|
|
|
|
To set the sensitivity
You can select the sensitivity level in the range of 1 to
10.The smaller the value you select, the higher the sensitivity becomes. Setting to 1 provides the highest sensitivity.
1Turn the Jog dial clockwise at the bottom right sensor point to highlight LEVEL and turn the Shuttle dial clockwise.
The current setting flashes.
The sensor is deactivated with LEVEL set to OFF.
2Turn the Jog dial to display the desired value, and turn the Shuttle dial clockwise to register the setting.
To end sensor setting
Highlight EXIT and turn the Shuttle dial clockwise. The previous display will be restored.
25 (GB)