When attaching to the cables

When you connect a cable to any of the terminals listed below, attach the ferrite core provided before using the cable.

AUDIO (INPUT1)

AUDIO (INPUT2)

AUDIO OUT REMOTE

Y/C IN (VIDEO)

AUDIO IN (VIDEO)

1 Attach the ferrite core (black) to the end of the cable closer to the PFM-42B2/42B2E, closing it firmly until your hear it click.

Within 10 mm (13/32 inch)

2 Wind the stopper round the cord so that the ferrite core does not slide.

Within 10 mm (13/32 inch)

3 Tighten the stopper and cut the surplus.

Connections

Connection ExampleBefore you start

•First make sure that the power to each piece of equipment is turned off.

•Use connecting cables suitable for the equipment to be connected.

•The cable connectors should be fully inserted into the jacks. A loose connection may cause hum and other noise.

•To disconnect the cable, pull it out by grasping the plug. Never pull the cable itself.

•Refer to the instruction manual of the equipment to be connected.

•Insert the plug securely into the AC IN socket.

•Use one of the two AC plug holders (supplied) that will securely hold the AC plug.

Notes

•When you connect this unit to various pieces of equipment using the RGB/YUV connectors, use the specified cable.

SMF-400 (D-Sub 15P - 5 BNC) SMF-410 (D-Sub 15P - D-Sub 15P)

•You are cautioned that this unit will not be in compliance with the EMC limits unless the ferrite core is installed on the interconnecting wire.

15 (GB)