Setting the NETWORK ADAPTOR (PFM-42B2/42B2E only) / Self-diagnosis Function / Operating a Specific Display With the Remote Commander

1 In the CONFIG (2/2) menu, Press v / V to move the cursor (B) to “NETWORK ADAPTOR” and press ENTER.

The following menu appears on the display panel.

N E T WO R K A D A P T O R

 

 

S T B Y P OW E R

:

O N

R E S E T

 

 

S E L E C T

S E T ENTER

E N D MENU

2 Press v / V to move the cursor (B) to “RESET” and press ENTER.

The following menu appears on the display panel.

R E S E T

:

N O

3 Press v / V to set RESET to YES and press

ENTER.

The Network Adaptor is restarted.

Self-diagnosis Function

The unit has a self-diagnosis function.

This function shows the display’s condition based on the pattern shown by the flashing of the STANDBY indicator. The flashing pattern informs you of the display’s current condition.

If the STANDBY indicator flashes, check the number of flashes and contact your authorized Sony dealer.

1 Check the flashing pattern of the STANDBY indicator.

The indicator flashes (with an image showing on the display) or flashes at intervals of three seconds (with no image showing on the display).

Count the number of flashes if the indicator flashes at intervals of three seconds. For example, the indicator flashes twice, followed by a three second pause, two more flashes and this pattern repeats. In this case, the count for the number of flashes is two.

2 Unplug the unit.Inform your authorized Sony dealer of the number of flashes.Operating a Specific Display With the Remote Commander

Using the supplied Remote Commander, you can operate a specific display without affecting other displays that are installed at the same time.

1 Press ID MODE ON on the Remote Commander. Monitor index numbers appear in white characters on all the displays. (Every display is allocated an individual preset index number from 1 to 255.)

See “To change the index number” on page 46 (GB) to change the index number.

Index number

I N D E X N o . 1 1 7 . . .

45 (GB)