Location and Function of Parts and Controls

8H SHIFT button

Adjusts the horizontal centering. Press this button and then adjust the horizontal centering with the SELECT +M/–mbutton qj.

9V SHIFT button

Adjusts the vertical centering. Press this button and then adjust the vertical centering with the SELECT +M/–mbutton qj.

0H SIZE button

Adjusts the horizontal picture size. Press this button and then adjust the horizontal picture size with the SELECT +M/–mbutton qj.

qa V SIZE button

Adjusts the vertical picture size. Press this button and then adjust the vertical picture size with the SELECT +M/–mbutton qj.

qs STANDBY buttonPress to turn the display to the standby mode.qd RGB/YUV button

Press to select the format matching that of the input signal connected to the INPUT1 or INPUT2 connector. Each press toggles between RGB and YUV.

qf S/VIDEO button

Press to select the signal input from the COMPOSITE IN connector or Y/C IN connector from among the VIDEO connectors. Each press toggles between COMPOSITE IN and Y/C IN.

qg Number buttonsPress to enter the index number.qh ID MODE (ON/SET/OFF) buttons

Press the ON button to make an index number appear on the screen. Then enter the index number of the display you want to operate using the number buttons qg and press the SET button. After you finish the operation, press the OFF button to return from the ID mode to the normal mode.

For details about the index number, see “Operating a Specific Display With the Remote Commander” on page 45 (GB).

qj SELECT +M/–mbutton

Press to move the cursor (B) to an item or to adjust a value in a menu.

qk MENU button

Press to make the menu appear. When the menu appears on the display panel, press to return to the previous menu level. To clear the menu, press this button repeatedly until the menu disappears.

ql ENTER buttonPress to select the desired item in a menu.w; BRIGHT +/– buttonAdjusts the brightness.wa CONTRAST +/– buttonAdjusts the contrast.Installing batteriesInsert two size AA (R6) batteries in correct polarity.

Be sure to install the negative <– end first.

E e

e

E

•In normal operation, batteries will last up to half a year. If the Remote Commander does not operate properly, the batteries might be exhausted sooner. Replace them with new ones.

•To avoid damage from possible battery leakage, remove the batteries if you do not plan to use the Remote Commander for a fairly long time.

When the Remote Commander does not work

Check that the STANDBY indicator lights up and the REMOTE MODE in the REMOTE menu is not set to OFF. The Remote Commander operates the display only when both of the two conditions below are met.

•The display is turned on, or it is in the standby mode.•The REMOTE MODE in the REMOTE menu is setto TV or to PJ.

For details about the REMOTE MODE, see “REMOTE menu” on page 22 (GB).

12 (GB)