ZZ...
ZZ...

Troubleshooting

Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the following messages appears on the screen. To solve the problem, see “Trouble symptoms and remedies” on page 20.

If OUT OF SCAN RANGE appears on the screen

This indicates that the input signal is not supported by the monitor’s specifications. Check the following items

For more information about on-screen messages, see “Trouble symptoms and remedies” on page 20

I NFORMA T I ON

OUT OF SCAN RANGE I NPUT 1 : DV I - D

x x x . x k H z / x x x H. zx

If “xxx.x kHz/xxx Hz” is displayed

This indicates that either the horizontal or vertical frequency is not supported by the monitor’s specifications.

The figures indicate the horizontal and vertical frequencies of the current input signal.

If “RESOLUTION > 1024 × 768” is displayed (SDM-X52)

This indicates that the resolution is not supported by the monitor’s specifications (1024 × 768 or less).

If “RESOLUTION > 1280 × 1024” is displayed (SDM-X72/X82)

This indicates that the resolution is not supported by the monitor’s specifications (1280 × 1024 or less).

If NO INPUT SIGNAL appears on the screen

This indicates that no signal is being input via the currently selected connector.

I NFORMA T I ON

NO I NPUT S I GNA L

I NPUT 1 : DV I - D

GO TO POWER SAVE

GO TO POWER SAVE

If the (POWER SAVE) is set to “ON,” the monitor will enter the power saving mode after about 5 seconds from the time the message is displayed.

If CABLE DISCONNECTED appears on the screen

This indicates that the video signal cable has been disconnected from the currently selected connector.

I NFORMA T I ON

CAB L E D I SCONNECT ED

I NPUT 1 : DV I - D

GO TO POWER SAVE

GO TO POWER SAVE

If the (POWER SAVE) is set to “ON,” the monitor will enter the power saving mode after about 5 seconds from the time the message is displayed.

GB

19

Page 19
Image 19
Sony SDM-X52 manual Troubleshooting, On-screen messages, If OUT of Scan Range appears on the screen