Programming the remote

You can customize the remote to match the components connected to your receiver. You can even program the remote to control non- Sony components and also Sony components that the remote is normally unable to control. The procedure below uses as an example a case in which the other manufacturer’s VCR is connected to the VIDEO 2 jacks on the receiver.

Before you begin, note that:

–You cannot change the settings of PHONO.

–The remote can control only components that accept infrared wireless control signals.

Be sure to turn on the receiver and point the remote towards the receiver when performing the following procedure.

1

2

3

4

1 Press AV ?/1 while pressing RM

SET UP.

The RM SET UP button flashes.

2 While the RM SET UP button is flashing, press the input button (including TV) for the component you want to control.

For example, if you are going to control a CD player, press SA-CD/CD.

The RM SET UP button and input button flash.

3 Press the numeric buttons to enter the numeric code (or one of the codes if more than one code exists) corresponding to the component and the maker of the component you want to control.

The RM SET UP button and input button light up.

Note

For a TV remote code value, only numbers in the 500’s are valid.

4 Press ENTER.

Once the numeric code has been verified, the RM SET UP button flashes twice and the remote automatically exits the programming mode. The input button also turns off.

To cancel programming

Press RM SET UP during any step.

108GB