Confirming/saving the measurement results

1 Confirm the measurement result.

When the measurement ends, a beep sounds and the measurement result appears on the display.

Measurement Display

Explanation

result

 

 

 

 

 

When the

COMPLETE

Proceed to step

measurement

 

2.

process

 

 

completes

 

 

properly

 

 

 

 

 

When the

ERROR

See “When

measurement

CODE XX

error codes

process fails

 

appear” (page

 

 

46).

2 Press V/v repeatedly to select the item, then press .

Item

Explanation

RETRY

Re-performs the auto

 

calibration.

 

 

SAVE EXIT

Saves the measurement

 

results and exits the setting

 

process.

 

 

WRN CHECK

Displays a warning

 

concerning the

 

measurement results. See

 

“When you select “WRN

 

CHECK”” (page 47).

 

 

PHASE INFO

Displays the phase of each

 

speaker (in phase/out of

 

phase). See “When you

 

select “PHASE INFO””

 

(page 47).

 

 

Item

Explanation

DIST.INFO

Displays the measurement

 

result for speaker distance.

 

 

LEVEL INFO

Displays the measurement

 

result for speaker level.

 

 

EXIT

Exits the setting process

 

without saving the

 

measurement results.

3 Press V/v repeatedly to select a preset number to be used, then press .

4 Press .

The measurement results are saved.

Tip

The size of a speaker (LARGE/SMALL) is determined by the low characteristics. The measurement results may vary, depending on the position of the optimizer microphone and speakers, and the shape of the room. It is recommended that you follow the measurement results. However, you can change those settings in the Speaker Settings menu (page 68). Save the measurement results first, then try to change the settings if you want.

When error codes appear

Try the remedies and re-perform the auto calibration.

Error code

Cause and remedies

CODE 31 SPEAKERS (OFF/A/B/A+B) is set to OFF. Set it to others and re- perform the auto calibration.

CODE 32 None of the speakers were detected. Make sure that the optimizer microphone is connected properly and re- perform the auto calibration. If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected.

CODE 33 (F) None of the front speakers are connected or only one front speaker is connected.

The optimizer microphone is not connected.

46GB