The image of the COMPONENT VIDEO OUT is corrupted.

•When the signals are output from the COMPONENT VIDEO OUT jack, input signals other than 480p are corrupted if “PROGRESSIVE OUT” is set to “ON.” Set “PROGRESSIVE OUT” to “OFF.”

•Video input signals other than 480p component are not received when signals are output from the S VIDEO jack or the VIDEO jack. Input 480i component video signals.

•When component input signals other than 480p are output, use the COMPONENT VIDEO OUT jack and set “PROGRESSIVE OUT” to “OFF.”

The source image input from the HDMI jack is not output from the receiver or the TV speaker connected to the receiver.

•Make sure that cables are correctly and securely connected to components.

•Depending on the playback component, component may need to be set up. Refer to the operating instructions supplied with the each component.

Recording cannot be carried out.

•Check that the components are connected correctly (page 26).

•Select the source component using INPUT SELECTOR (page 50).

Tuner

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna (aerial) as shown below. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe.

Outdoor FM antenna (aerial)

Receiver

To ground

Ground (earth) wire (not supplied)

Radio stations cannot be tuned in.

•Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning.

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 84).

•Press DISPLAY so that the frequency appears on the display.

Remote control

The remote does not function.

•Point the remote at the remote sensor on the receiver.

•Remove any obstacles in the path between the remote and the receiver.

•Replace all the batteries in the remote with new ones, if they are weak.

•Make sure that the command modes of the receiver and the remote are the same. If the command mode of the receiver and the remote are different, you cannot operate the receiver with the remote (page 40).

continued

Information Additional

123GB