Notes on converting video signals

You can convert only 480i component video signals into HDMI signals, S video signals, or video signals. Signals are converted from 480i interlace scanning to 480p progressive scanning, then the signals are output.

When video or S video signals from a VCR, etc., are converted on this receiver and then output to your TV, depending on the status of the video signal output, the image on the TV screen may appear distorted horizontally or no image may be output.

HDMI video signals cannot be converted to component video signals, S video signals, and video signals.

The converted video signals are output only from the MONITOR OUT jacks. They are not output from VIDEO OUT jacks,

S VIDEO OUT jacks, or the ZONE 2 VIDEO OUT jack.

S2 information (aspect information for the images) included in S video signals is effective only when S video input signals are output from the S video MONITOR OUT jack. An aspect ratio of images may not be displayed correctly when video signals and component video signals are converted and are output from the S video MONITOR OUT jack.

When you play a VCR with an image improvement circuit, such as TBC, the images may be distorted or may not be output. In this case, set the image improvement circuit function to off.

Closed Caption display

When the receiver receives video output signals that are up-converted but the accompanying closed caption cannot be displayed, down-convert the video output signals to the original video signals, and connect the TV to the MONITOR OUT jack that outputs the original video signals.

To connect a recording component

When recording, connect the recording component to the VIDEO OUT jacks or S VIDEO OUT jacks of the receiver. Connect cords for input and output signals to the same type of jack, as VIDEO OUT jacks and S VIDEO OUT jacks do not have an up- conversion function.

Note

Signals output from the MONITOR OUT jacks may not be recorded properly.

36GB