There is no sound from one of the front speakers.

Connect a pair of headphones to the PHONES jack to verify that sound is output from the headphones. If only one channel is output from the headphones, the component may not be connected to the receiver correctly. Check that all the cords are fully inserted into the jacks on both the receiver and the component. If both channels are output from the headphones, the front speaker may not be connected to the receiver correctly. Check the connection of the front speaker which is not outputting any sound.

Make sure you have connected both the L or R jack to an analog component and not just to either the L or R jack. Use a monaural-stereo cable (not supplied). However, there will be no sound from the center speaker when a sound field (PRO LOGIC, etc.) is selected. When the center speaker is set to “NO,” sound is output only from the front left/right speakers.

There is no sound from analog 2 channel sources.

Check that the INPUT MODE is not set to “COAX” nor “OPT” for the selected input (page 93).

Check that the MULTI IN is not selected.

Check that the DIGITAL ASSIGN function is not used to reassign the audio input of another source to the selected input (page 94).

There is no sound from digital sources (from COAXIAL or OPTICAL input jack).

Check that the INPUT MODE is not set to “ANALOG” (page 93). Check that the INPUT MODE is not set to “COAX” for the sources from the OPTICAL input jack, nor set to “OPT” for the sources from the COAXIAL input jack.

Check that the MULTI IN is not selected.

Check that the ANALOG DIRECT function is not being used.

Check that the DIGITAL ASSIGN function is not used to reassign the audio input of another source to the selected input (page 94).

The source sound input from the HDMI jack is not output from an amplifier or the TV speaker connected to the receiver.

Check that the component is connected correctly to the HDMI jack for that component.

The sound is not output when you display the receiver’s menu on the TV monitor. Press ON SCREEN to turn off the display.

You cannot listen to the Super Audio CD by connecting HDMI.

Depending on the playback component, component may need to be set up. Refer to the operating instructions supplied with the each component.

The left and right sounds are unbalanced or reversed.

• Check that the speakers and components are connected correctly and securely.

• Adjust the balance parameters using the

Level Settings menu.

 

 

 

 

 

 

 

There is severe hum or noise.

 

 

• Check that the speakers and components

Additional

are connected securely.

 

• Check that the connecting cords are away

 

from a transformer or motor, and at least 3

 

m (10 feet) away from a TV set or

Information

• Make sure you have grounded the U

fluorescent light.

 

• Move your TV away from the audio

 

components.

 

SIGNAL GND terminal (only when a

 

turntable is connected).

 

• The plugs and jacks are dirty. Wipe them

 

with a cloth slightly moistened with

 

alcohol.

 

continued

121GB