surround back speakers are also | • NO |
automatically set to “SMALL” (unless | If you have not connected surround |
previously set to “NO”). | speakers, select “NO.” |
xCENTER SP (Center speaker)
• LARGE
If you connect a large speaker that will effectively reproduce bass frequencies, select “LARGE.” Normally, select “LARGE.” However, if the front speakers are set to “SMALL,” you cannot set the center speaker to “LARGE.”
• SMALL
If the sound is distorted, or you feel a lack of surround effects when using
• NO
If you have not connected a center speaker, select “NO,” the sound of the center channel will be output from the front speakers.
• MIX
If you have not connected a center speaker, select “MIX.” The sound of the center channel will be output without affecting sound quality.
xSURROUND SP (Surround speaker)
The surround back speakers will be set to the same setting.
•LARGE
If you connect large speakers that will effectively reproduce bass frequencies, select “LARGE.” Normally, select “LARGE.” However, if the front speakers are set to “SMALL,” you cannot set the surround speakers to “LARGE.”
•SMALL
If the sound is distorted, or you feel a lack of surround effects when using
x SUR BACK SP (Surround back speakers)
When the surround speakers are set to “NO,” |
| |
the surround back speakers are also |
| |
automatically set to “NO” and the setting |
| |
| ||
cannot be changed. |
| |
• DUAL | Amplifier | |
If you connect two surround back speakers, | ||
| ||
select “DUAL.” The sound will be output to |
| |
a maximum of 7.1 channels. |
| |
• SINGLE | Operations | |
If you connect only one surround back | ||
| ||
speaker, select “SINGLE.” The sound will |
| |
be output to a maximum of 6.1 channels. |
| |
• NO |
| |
If you have not connected surround back |
| |
speakers, select “NO.” |
| |
• ZONE 2 |
| |
If you use the surround back speaker in zone |
| |
2, select “ZONE 2.” When you select |
| |
“ZONE 2,” the input to the SURROUND |
| |
BACK jacks of the MULTI CHANNEL |
| |
INPUT is invalid (page 24). |
| |
• |
| |
If you connect front speakers in a bi- |
| |
amplifier configuration, select |
| |
(page 104). |
|
Tip
The “LARGE” and “SMALL” settings for each speaker determine whether the internal sound processor will cut the bass signal from that channel. When the bass is cut from a channel, the bass redirection circuitry sends the corresponding bass frequencies to the sub woofer or other “LARGE” speakers.
However, since bass sound has a certain amount of directionality, it is best not to cut them, if possible. Therefore, even when using small speakers, you can set them to “LARGE” if you want to output the bass frequencies from that speaker. On the other hand, if you are using a large speaker, but prefer not to have bass frequencies output from that speaker, set it to “SMALL.”
continued
69GB