•Make sure you select the correct input on the remote.

•When you operate a programmed non- Sony component, the remote may not function properly depending on the model and the maker of the component.

Error message

If there is a malfunction, the display shows a code of two numbers and a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.

PROTECTOR

Irregular current is being output from the speakers, or the upper panel of the receiver is covered with something. The receiver will automatically turn off after a few seconds. Check the speaker connection and turn on the power again.

Reference sections for clearing the memory

To clear

See

All memorized settings

page 39

 

 

Customized sound fields

page 81

 

 

SpecificationsAUDIO POWERSPECIFICATIONS

POWER OUTPUT AND TOTAL HARMONIC DISTORTION:

With 8 ohm loads, both channels driven, from 20 – 20,000 Hz; rated 120 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output.

Amplifier section

POWER OUTPUT

Rated Power Output at Stereo Mode1) 2)

(8 ohms 20 Hz – 20 kHz, THD 0.09%):

120 W + 120 W

Reference Power Output at Stereo Mode2)

(4 ohms 20 Hz – 20 kHz, THD 0.15%):

120 W + 120 W

Reference Power Output

(8 ohms 1 kHz, THD 0.7%) FRONT2):

130 W + 130 W CENTER2):

130W SURROUND2):

130W + 130 W SURROUND BACK2):

130W + 130 W

Reference Power Output

(4 ohms 1 kHz, THD 0.7%)

FRONT2):

130 W + 130 W

CENTER2):

130W SURROUND2):

130W + 130 W SURROUND BACK2):

130W + 130 W

1)Depending on the sound field settings and the source, there may be no sound output.

2)Measured under the following conditions: Power requirements: 120 V AC, 60 Hz

124GB