Stanton SCS.4DJ Don’t see my entire collection in the browse list?, My problem isn’t covered here

the auto SYNC engine. If it is still wrong, you can use the TAP BPM button to get the correct BPM, though please note that the SCS.4DJ will still use the BEAT GRID from the initial analysis.

7. I don’t see my entire collection in the browse list?

There are a few reasons that you may not see your entire collection in the browse list. If some of your tracks are not playable by the SCS.4DJ (ie: files in data formats that SCS.4DJ does not support) they will not appear in your browse list. If you look under the SYSTEM menu -> Devices -> Unplayable Songs, a list of your tracks that can not be played due to incorrect format or data corruption in the file are listed.

If you have inserted a large device for the first time it can take a long time to find and display all of

the songs in your collection. The scanning icon will display in the center of the status header when your songs are being discovered. The scanning icon will display when the first page of your browse list is available but your browse list is not yet completely available. This icon will go away when the full collection is available for browsing.

Also note, there is a 20,000 song limit per drive, so, if you have a collection larger than 20,000 songs, only your first 20,000 songs will be available.

8.It is very difficult to turn the storage compartment locking tabs on the bottom of the unit (when removing the bottom cover)

Especially when SCS.4DJ systems are new, those locking tabs can be hard to turn with just your fingers. On the top of each locking tab is a slot in which the edge of a coin can be placed to make turning them easier.

9. I locked my system and I can’t unlock it

Press the BACK and ENTER buttons together to unlock your system.

10. AUTO-DJ mode isn’t playing my entire playlist

AUTO-DJmode will skip over any songs you have played so far. If you want a song to play again, you must re-load it in your playlist. If your playlist contains songs that are not resident on your currently attached storage devices SCS.4DJ will skip over them.

11. The LED by the PITCH FADER isn’t lighting up when the PITCH FADER is in the middle

The LED by the PITCH FADER lights up when SYNC is turned on and the PITCH FADER position is not the same as the physical position, not when the PITCH FADER is at zero.

12. SCS.4DJ is not remembering my CUE POINTS

Please make sure that your SCS.4DJ is set to “Cue at user CUE point” from within the AUDIO SETTINGS menu, called up using the SYSTEM button.

13. My problem isn’t covered here

Please go to www.stantondj.com/scs4dj.htm for all of the latest troubleshooting updates and information.

60