Sun Microsystems CP3240 manual Changing Serial Location from UBoot

4.5Serial Location

The switch supports running its serial port to both the front panel and the RTM. It does not support both the front panel and RTM at the same time. You must configure the port to go to the location needed. By default, the port is routed to the front panel.

4.5.1Changing Serial Location from UBoot

In this example, the serial port direction is to the RTM.

CODE EXAMPLE 4-1Serial Port Change from uBoot

CPU: 400 MHz

DRAM: 256 MB

FLASH: 64 MB, Base, Primary Flash

Use the [`] key above the TAB key to switch between BASE and FABRIC. [Break UBoot by pressing a key when the switch boots]

=> set console rtm

[set console to front for the front panel] => save

Saving Environment to Flash...

Un-Protected 1 sectors Erasing Flash...

. done

Erased 1 sectors Writing to Flash... done Protected 1 sectors

=> boot

4.5.2Changing Serial Location from FASTPATH

In this example, the serial port direction is changed to the RTM. Note that the change is instantaneous and lasts though a reboot.

CODE EXAMPLE 4-2Serial Port Change from FASTPATH

configure lineconfig

serial location rtm

[set location to front for the front panel]

Chapter 4 Configuring Switch Software 4-9