Sun Microsystems CP3240 manual Boot Sequence, Following is an example of a boot sequence

4.6Boot Sequence

The following is an example of a boot sequence.

CODE EXAMPLE 4-3Boot Sequence Example

CPU: 400 MHz

DRAM: 256 MB

FLASH: 64 MB, Base, Primary Flash

###JFFS2 loading 'image1' to 0x400000 Scanning JFFS2 FS: . done.

###JFFS2 load complete: 10026500 bytes loaded to 0x400000 Booting ...

Loading Ramdisk to 0fdf6000, end 0ff8d4c2 ... OK

Mounting /dev/mtdblock2 at /mnt/fastpath...done.

Mounting tmpfs at /mnt/application...done.

*****************************************************************

***

* Use the [`] key above the TAB to switch between BASE and FABRIC. *

*****************************************************************

***

switch, Base, Primary Flash, image1

Select startup mode. If no selection is made within 5 seconds,

the Application will start automatically...

--- Main Menu ---

1 - Start Switch Application

2 - Display Utility Menu Select (1, 2):

Extracting Application from image1.....done

Loading Application...done.

SOC unit 0 attached to PCI device BCM56503_B2

FASTPATH starting...started!

(Unit 1)>

User:

4-10Sun Netra CP3240 Switch Installation Guide • September 2009