SUPER MICRO Computer 6014L-M manual USB Configuration, System Health Monitor

SUPERSERVER 6014L-M User's Manual

￿USB Configuration

USB Function

This feature allows you to enable the USB Ports. The options are Disabled and

Enabled.

Legacy USB Support

Select Enabled to enable USB Legacy support. Disable legacy support if there are no USB devices installed in the system. The options are Disabled, Enabled, and Auto.

USB 2.0 Controller

This setting allows you to enable or disable the USB 2.0 Controller. The options are Disabled and Enabled.

USB 2.0 Controller Mode

This setting allows you to confi gure the USB 2.0 Controller Mode. The options are Hi-Speed (480 Mbps) and Full Speed-(12Mbps).

￿USB Mass Storage Device Configurations

USB Mass Storage Reset Delay

This setting allows you to decide how long the system should wait in an attempt to detect the presence of a USB Mass Storage Device before it issues a start command the system to proceed with the next operation during POST. The options are 10 Seconds, 20 Seconds, 30 Seconds and 40 Seconds.

Emulation Type

If set to Auto, USB devices that are smaller than 530MB will be emulated as

floppy and the remaining will be emulated as an HDD. The Forced FDD option will allow you to confi gure an HDD formatted drive to boot as an FDD (eg. Zip Drive). The options are Auto, Floppy, Forced FDD, Hard Disk, and CD ROM.

￿System Health Monitor

This feature allows the AMI BIOS to automatically display the status of the follow- ing items:

CPU Overheat Temperature

This feature allows the user to set the CPU Overheat temperature threshold. The options range from 65oC to 90oC. Use the <+> and <-> keys to set the desired setting. The default setting is 78oC.

7-14