Chapter 4: AMI BIOS
Configuration Request, permitting access to Extended Functions in an ARI device immediately below the port. The options are Disabled and Enabled.
AtomicOp Requester Enable (Available when supported by the hardware)
When set to Enabled, this feature initiates AtomicOp requests only if Bus Mas- ter Enable bit is in the Command Register set. The options are Disabled and Enabled.
AtomicOp Egress Blocking (Available when supported by the hardware)
When set to Enabled, this feature blocks outbound AtomicOp Requests via Egress ports. The options are Disabled and Enabled.
IDO Request Enable (Available when supported by the hardware)
When set to Enabled, this feature permits setting the number of
IDO Completion Enable (Available when supported by the hardware)
When set to Enabled, this feature permits setting the number of
LTR Mechanism Enable (Available when supported by the hardware)
When set to Enabled, this feature enables the Latency Tolerance Reporting mechanism. The options are Disabled and Enabled.
When set to Enabled, this feature blocks forwarding of TLPs containing
Target Link Speed (Available when supported by the hardware)
When set to Force to 2.5 or 5.0 GT/s, this feature sets an upper limit on the link operational speed of downstream ports by restricting the values advertised by the upstream component in its training sequences. When set to Auto, HW initialized data will be used. The options are Auto, Force to 2.5 GT/s, and Force to 5.0 GT/s.
Clock Power management (Available when supported by the hardware)
When set to Enabled, this feature permits the device to use CLKREQ# signal for power management of link clock in accordance to protocol defined in appropriate form factor specification. The options are Disabled and Enabled.
