TacT Audio owner manual Unpacking the RCS 2.0S, Accessories Operating voltage, Tact Audio

Accessories

Operating voltage

Unpacking the RCS 2.0S

Carefully remove the RCS 2.0S and accessory kit from the carton and visually check for shipping damage. Contact both the shipper and Tact Audio immediately if the unit shows any sign of damage from rough handling. All Tact Audio equipment is carefully inspected before leaving our factory.

KEEP THE SHIPPING CARTON AND PACKING MATERIALS for future use or in the unlikely event that the unit needs servicing. If this unit is shipped without the original packing, damage could occur and void the warranty.

You should find the following items in the accessory kit:

-one AC mains cord

-RJ11 data cable

-RJ11-to-RS232 adapter

-15’ RS232 cable

-CD-rom with RCS software

-Measurement microphone

-remote control

-2 AAA batteries

-this manual

The RCS-2.0 S is designed with an automatic switching power supply. It will operate on 65-265 volts at 50-60hz.No external settings are required.

The RCS-2.0 S has three operating modes:

- OFF	AC mains power is cut off, either via the rear
	panel mains switch, or by unplugging the unit from the
	wall outlet.

-STANDBY The unit is powered but all outputs are muted and the display is off. The unit uses very little current and

is “idling” or “sleeping”. Use the remote or front panel “STANDBY” button to toggle between ON and STANDBY.

- ON Everything is powered and ready to go.

Tact Audio 7