TacT Audio RCS 2.0S owner manual Quick Setup, Before You Begin, Tact Audio

Before You Begin

Quick Setup

The Tact 2.0S Quick Setup wizard is designed to help both the first time and experienced user perform complete room correction and create nine correction presets quickly and easily. To perform the Quick Setup successfully you will need to know your speaker configuration, your loudspeakers lower cut-off frequency, and the type of amplifier(s) that you have connected. This information will allow the Quick Setup to automate the room correction process for you so that you can begin enjoying the benefits of room correction immediately. For a detailed explanation of all of the software features and instruction for performing room correction manually please see the online help available in the software.

1 - Connect the RS 232 “Input” jack on the back of the RCS 2.0S to your computers serial port using the supplied cables and adapters.

NOTE: These instructions assume that you have already established communication between the RCS 2.0S and the Room Correction Software on your computer. See page 25.

2 - If you have one or more TacT M2150/S2150 digital amplifiers connect them to the RCS 2.0S. Please make sure that a unique address has been set for each device. For further instructions please refer to your M2150/S2150 owner’s manual.

CAUTION: To avoid damage through static discharge, we strongly recommend to turn off the RCS 2.0 S at the rear panel mains switch before connecting the microphone.

3 - Make sure that the RCS 2.0S is powered off from the rear panel mains switch and connect the supplied measurement microphone to the “Mic Input” connector on the back of the RCS 2.0S. Place the mic at the primary listening position at the height of your head. This will require a microphone stand, or something similar.

4 - Turn your RCS 2.0S on.

5 - Set the OUT setting for the RCS 2.0S. This is the speaker configuration your system will be using. Please refer to page 18 for more information and instructions.

6 - Turn on your computer and start the TacT 2.0S Correction Software. If you have not installed the software please see page 24 for instructions.

7 - Enable your microphone if you are using the Tact microphone that came with your unit. To enable or disable the microphone click on the “mic:” display window found on the main screen with your left mouse button to toggle its setting. When the microphone number is displayed it is enabled. If you have not installed your microphone please see page 24 for instructions.

Tact Audio 29