TANDBERG D14128.02 manual Presentation commands, XCommand Key Release, XCommand Presentation Start

Codec C90

Contents Introduction Getting Started Interfaces About the API xConfiguration

System Integrator Guide

xCommandxCommand xStatus Cameras Appendices Contact us

xCommand Key Release

Command used to emulate release an already pressed key on the remote control. The Key Release command should be preceded by a Key Press command to emulate pressing the key.

Required parameters with (r):

Key(r): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/ Layout/Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/ Square/SrcAux/SrcCamera/SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/ VolumeUp/ZoomIn/ZoomOut>\nExample:

xCommand Key Release Key:Home

*r KeyReleaseResult (status=OK):

*r/end

OK

The Presentation commands

xCommand Presentation Start

Will open dual presentation stream using selected presentation source when in call (if presenter option is installed). When not in call, the selected presentation source will be displayed.

Required parameters with (r):

PresentationSource: <1..5>

Example:

xCommand Presentation Start PresentationSource:2

OK

*r PresentationStartResult (status=OK): *r/end

xCommand Presentation Stop

Will stop dual presentation stream when in call. Will stop displaying presentation source locally when not in call.

Example:

xCommand Presentation Stop

OK

*r PresentationStopResult (status=OK): *r/end

D14128.02—NOVEMBER 2008 76