TANDBERG D14128.02 manual The SString Send command, The Standby commands, xCommand SStringSend

Codec C90

Contents Introduction Getting Started Interfaces About the API xConfiguration

System Integrator Guide

xCommandxCommand xStatus Cameras Appendices Contact us

The SString Send command

xCommand SStringSend

Used to send data to far end, e.g. for control systems. Uses the H.224 data channel (UDP). Required parameters with (r):

Message(r): <S: 1, 256>

CallId: <0..65534>

Example:

xCommand SStringSend CallId:4 Message:”This is a test” *r SStringSendResult (status=OK):

*r/end

OK

The Standby commands

xCommand Standby Activate

Set system in standby mode.

Example:

xCommand Standby Activate

*r ActivateResult (status=OK): *r/end

OK

xCommand Standby Deactivate

Bring system out of standby mode.

Example:

xCommand Standby Deactivate

*r DeactivateResult (status=OK): *r/end

OK

xCommand Standby ResetTimer

System will enter standby mode after time specified by Delay parameter.

Required parameters with (r):

Delay: <1..480>

Example:

xCommand Standby ResetTimer Delay:10 *r ResetResult (status=OK):

*r/end

OK

D14128.02—NOVEMBER 2008 78