TANDBERG D14128.02 manual Turn on the system, Verify IP address settings, Show the menu, Codec C90

Codec C90

Contents Introduction

System Integrator Guide

GettingGettingStartedStarted Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us

1	Turn on the system
	•	Turn on the codec and wait a few minutes for the system to start
	• Make sure the remote control has the batteries installed.
	•	Press Home (   ) on the remote control to show the menu on screen
	• When you can see the menu on screen, proceed to Step 2.

Show the menu:

•Press Home (   ) on the remote control to show the menu on screen

Navigate in the menu:

•Use the arrow keys on the remote control to navigate up and down in the menus

Confirm your choice:

	•	To confirm your choice, press OK ( ) on the remote control
2	Verify IP address settings
	Go to System Information to verify the IP address:
	1.	Navigate to Settings > System Information
	2.	When the IP address is automatically assigned from a DHCP server, the
		Address of the codec is shown on the System Information page.
	3.	Press Home (   ) to exit.

3	If you need to set a static IP address
	Go to IP Settings to set static IP addresses:
	1. Navigate to Settings > Administrator Settings > IP Settings.
	2.	Set IP Assignment to Static. Press the left arrow key to go back one step
	3.	Enter the IP Address, Subnet Mask and Gateway address in the address fields.
		The sequence is shown below.
	4.	Press OK to save the changes, or Cancel to leave without saving.
	5.	Press Home (   ) to exit.

D14128.02—NOVEMBER 2008 12