TANDBERG D14128.02 manual About monitors, The main monitor, Dual monitors, When connecting to HDMI

Codec C90

Contents Introduction

System Integrator Guide

GettingGettingStartedStarted Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us

About monitors

The main monitor

The main monitor can be connected to the default video output HDMI 1 or one of the other outputs which are HDMI 3, DVI-I 2 or DVI-I 4.

When connecting to HDMI 1

When you connect the main monitor to the default video output on Codec C90 the menu, icons and other information on screen (OSD - on screen display) will show on this monitor.

When connecting to DVI-I 2, DVI-I 4, HDMI 3

When connecting the main monitor to another video output, and no menu shows on screen, you must run a shortcut on the remote control to reset the resolution and move the OSD to this output.

The resolution will be set to the default value, which is 1280x720@60Hz for HDMI and 1024x768@60Hz for DVI.

The menu on screen, icons and other information (OSD - on screen display) will be moved to the selected output.

Key sequence

If connected to DVI-I 2, DVI-I 4 or HDMI 3 you must run the following shortcut or key sequence on the remote control.

•Disconnect * # * # 0 x # (where x is output 2, 3 or 4) Example: Set DVI-I 2 as the OSD output:

The video outputs at Codec C90

DVI-I 4

HDMI 3

(the default connector for the dual monitor)

DVI-I 2

HDMI 1

(the default connector for the main monitor)

Dual monitors

When you want to run a dual monitor setup, connect the second monitor to video output HDMI 3 on Codec C90.

•Disconnect * # * # 0 2 #

You can also set the resolution and the OSD output by setting up a serial port connection and run API commands. See the Codec C90 System Integrator Guide for information about API commands.

Dual monitor configuration

Go to Administrator settings to set the monitor to dual:

1.Navigate to Settings > Administrator Settings > Video > Output > Monitor

2.Set the Monitor to Dual.

3.Press Home (   ) to exit.

D14128.02—NOVEMBER 2008 14