Tandberg Data 7000 manual Adding an extra site dial, Disconnecting sites from a conference

TANDBERG Videoconferencing System General use

Adding an extra site - dial in

To dial in to the MultiSite on ISDN-BRI:

•Site 2 must dial MultiSite Number 2.

•Site 3 must dial MultiSite Number 3.

TIP

TO FIND THE DIAL-IN NUMBERS FOR THE MULTISITE,

PRESS ‘MENU’ AND ‘SYSTEM INFO’

To dial in to the MultiSite on ISDN-PRI:

• Dial the main number of the system (‘My ISDN Number’). All sites can dial the same number.

To dial in to the MultiSite on IP:

•Dial the IP Number or the IP Address of the system (‘My IP Number’/‘My IP Address’). When the MultiSite receives an incoming call, the following menu is displayed:

•Pressing CONNECT is equivalent to pressing ‘Accept’.

•Pressing DISCONNECT is equivalent to pressing ‘Reject’.

•Pressing ‘Do Not Disturb’ will disable the MultiSite from answering more incoming calls during the current conference. The calling party will receive a busy signal.

Disconnecting sites from a conference

disconnect To disconnect a site or end the conference, press DISCONNECT.

• Select site and press OK or ‘Disconnect Site’.

To end the meeting press ‘Disconnect All’.

NOTE

EACH SYSTEM WILL BE IDENTIFIED BY A SYSTEM NAME (IF SUPPORTED) AND THE NUMBER OF THE FAR END.

43