Tandberg Data 7000 manual Getting started, System start-up, Welcome menu

TANDBERG Videoconferencing System Getting started

Getting started

System start-up

Your system should be in standby mode. When in standby mode, pressing any key or picking up the remote control will wake up the system. An incoming call will also wake up the system.

If the system does not respond, make sure the system is switched on by using the On/Off switch located at the rear of the Codec (see figure below). After a few seconds you should see a ‘Welcome’ menu on the monitor.

If this does not help, verify that your monitor is switched on.

Welcome menu

After a user-definable boot-up logo is shown, the following ‘Welcome’ menu is shown. This screen should provide you with the most important system information. For further system information, select the Quick key ‘System Info’.

21