1 SpeedTouch™ Installation
1.2 | Setting up the SpeedTouch™ | ||
Local network |
| ||
For Ethernet connectivity you need at least: | |||
| • | A computer with installed Ethernet Network Interface Card (NIC) or available | |
|
| ||
| • | If needed, a hub or switch and the necessary connection cables | |
Ethernet Cables |
| ||
In the SpeedTouch™605s box, a full wired Cat.5 | |||
| cable, further referred to as LAN cable is included. | ||
| You can use LAN cables other than the one provided in the box. However make sure to | ||
| use correct connection cables. | ||
Wiring procedure |
| ||
Proceed as follows: | |||
| 1 | Use the included LAN cable to wire your computer's Ethernet port to the | |
|
| SpeedTouch™605s Ethernet port. | |
| 2 | Use the included DSL cable to wire the SpeedTouch™605s's Line port to your | |
|
| telephone wall outlet. | |
| 3 | Plug the power adapter's coaxial jack into the SpeedTouch™605s DC inlet and | |
|
| plug the power adapter in a wall outlet. | |
|
| Note | Always check first whether the included power adapter suits the local |
|
|
| power specifications. |
More information on |
| ||
For more information, see the application note “The SpeedTouch™ and Ethernet | |||
Ethernet wiring | Connectivity”. |
| |
PC wiring |
| ||
Once all connections are made, the result should look similar as below: | |||
6 | |
|
