3 SpeedTouch™ Web Interface
DHCP Click this link to display the Dynamic Host Configuration Protocol (DHCP) page. This page allows you to:
•Click the DHCP Server tab to access the DHCP server page. This page has three tabs:
•Click the Server Config tab to enable/disable the SpeedTouch™ (Auto)DHCP server:
Depending on the DHCP server status, following Status may be shown:
•Scanning for other DHCP server:
When the DHCP server and its Auto DHCP feature are enabled, during local network probing on the SpeedTouch™ Ethernet interface eth0.
•DHCP server stopped:
When the DHCP server and its Auto DHCP feature are enabled, and a concurrent DHCP server was found during probing, thus causing its own DHCP server to be stopped and a DHCP client on the SpeedTouch™ Ethernet interface eth0 be created and activated.
•DHCP server started:
When the DHCP server and its Auto DHCP feature are enabled, and no concurrent DHCP server was found during network probing, thus starting its own DHCP server on the SpeedTouch™ Ethernet interface eth0.
•DHCP server running:
When the SpeedTouch™ DHCP server is enabled by default (without DHCP client)
•DHCP client:
When SpeedTouch™ server is disabled by default, and a DHCP client is running on the SpeedTouch™ Ethernet interface eth0.
•No DHCP:
When the SpeedTouch™ server is disabled by default and the SpeedTouch™ Ethernet interface eth0 IP address is statically assigned.
44 | |
|
