TE-PLAQUINDUCTION-NC00127885_Q7_final 12/9/14 11:37 Page 27
Common Malfunction | Malfunction Check |
|
|
The cooker stops heating | • Check if the room temperature is too high; |
during use | • Check if air entry/ air exit is blocked ; |
| • For boil and milk modes, the hob stops |
| automatically when it reaches maximum |
| temperature. |
| • Check if the appliance has been stopped |
| by a safety device. In this case, wait for |
| several minutes to confirm. |
|
|
EN
Please Note: If the power cord is damaged do not use the appliance. Have it replaced by a TefalApproved Service Centre to avoid any danger.
ERROR CODES
•Receptaclemissingor not the correcttype:
if the pot base diameter is less than 12 cm or if the pot material is unsuitable, the buzzer will sound and the digital display shows E1. Changer de cookware.
•Protectionof the powersourceagainstoverheating:
If the power source overheats, the induction cooking appliance cuts off the incomingpower supply and the screen displays E2. Laisser la plaque refroidir:si le défautpersistemerci de contacterle SAV.
•Over or under- voltage protection:
If the voltageis greaterthan 265 V - 285 V, the incomingpower supply for the inductioncookingapplianceis cut off and the digitalscreen displays"E3"; if the voltageis between150V and170V, theincomingpowersupplyfortheinduction cookingapplianceis cut off and the digitalscreendisplays"E4". Vérifierque votre appareilest en correspondanceavecvotreréseauélectrique.
•Temperaturesensor:
If the sensor is in an open circuit,the inductioncooking appliancewill continue to operate for one minute and the digital screen will display "E5"; if the sensor detectsa short circuit,the inductioncookingappliancewill immediatelydisplay E6. Contacterle SAV.
•NTC abnormal protection:
when NTC value change is small for IH working 5min, the induction cooker will shut off the input power and the display shows E7.
27
