TOA Electronics VM-2120 instruction manual Remote Microphone RM-200M Top

6.2.Remote Microphone RM-200M [Top]

2

3

4 5

6

7

8

9

10

1 2

11

12

13

14

10.	All-zone broadcast key (ALL-ZONE)
	Press this key to make the All-Zone Broadcast.
11.	Zone selector key (ZONE 1 – 5)
	Selects the desired broadcast zones (Zones 1 – 5).
12.	Zone indicator (ZONE 1 – 5)
	Lights green when the corresponding broadcast
	zone (Zones 1 – 5) is selected.
13. Message (MESSAGE 1 – 5)/zone (ZONE 6 –
	10) selector key
(1) When only a single VM-2120 or VM-2240
	amplifier is connected

15 16 17

1.Gooseneck microphone

A unidirectional microphone.

2.Name label

Insert the label (not thicker than 0.2 mm) indicating the name of each panel control and indicator. (See p. 60 "NAME LABEL PREPARATION.")

3.Power indicator (POWER)

Lights green when the power is supplied to the unit.

4.Failure indicator (FAULT)

Lights yellow when the VM (VM-2120/-2240) amplifier's front panel-mounted failure indicator lights.

Flashes yellow when a communications failure occurs between the unit and the VM amplifier.

5.Emergency indicator (EMERGENCY)

Lights red when the VM amplifier is in Emergency mode. (See p. 21.)

6.Emergency broadcast switch (EMERGENCY) Press this switch after opening the security cover when making the Emergency Broadcast.

7.Groups 1&2 indicator (GROUP 1, 2)

Lights green when the corresponding group is selected with the key.

8.Groups 1&2 broadcast key (GROUP 1, 2) Press this key to make the Group Broadcast (Broadcast to preprogrammed multiple zones). (See p. 51 "BROADCAST GROUP/ZONE SETTING.")

9.All-zone indicator (ALL-ZONE)

Lights green when the All-Zone Broadcast is selected with the key.

Selects broadcast messages 1 – 5 pre-recorded

on the optional Voice Announcement Board EV-

200.

(2) When two VM-2120 or VM-2240 amplifiers are

connected

Selects broadcast zones 6 – 10.

14. Message (MESSAGE 1 – 5)/zone (ZONE 6 –

10) indicator

Lights green when the corresponding Message (Zone) Selector Key is pressed.

15.Busy indicator (BUSY)

Flashes orange or green when other connected sound source unit is in use.

Orange: The RM-200M cannot operate.

Green: The RM-200M can interrupt the busy unit.

16.In-use indicator (IN-USE)

Lights green when the RM-200M is in use.

17.Talk key (TALK)

Either of the following two operating methods can be selected. (See p.50 "Remote Microphone's Function Switches.")

(1)Press-to-talk system

Announcements can be made from the microphone while the key is pressed, and are terminated when released.

(2)Talk lock system

One-touch depression locks the key and permits announcements to be made from the microphone. Press the key again to terminate the announcement.

Note

In the Emergency Broadcast, the Talk key operates in the "press-to-talk" system even if set to the "Talk lock system."

12