24.3. Zone-to-Group Assignment Operation
•Here, the operation example of assigning Broadcast Zones 2 – 4 to Group 2 will be explained for a
•In the case of 10 broadcast zones (i.e. connection of a master unit to a
Lighting status
Extinguished | Lighting | Flashing | Quick flashing* | Slow flashing* |
* See p. 55 Indicator status.
Step 1. Entry to broadcast group setting mode
Press and release the Reset key while holding down the ZONE 1 and ZONE 2 keys. When all indicators for Zones 1 – 5 begin to flash (2 – 3 seconds after), release both the ZONE 1 and ZONE 2 keys.
Use a precision screwdriver or other long, pointed object (2.5 mm in diameter and over 30 mm in length) when pressing the Reset key.
Note: Even when a
The unit will be placed in broadcast group setting mode.
The 5 indicators for ZONE 1 through ZONE 5 begin to flash. (They indicate Group 1 through Group 5.) Another 5 indicators for ZONE 6 through ZONE 10 will also flash if a
Step 2. Group number selection (Example: Group 2)
Press the ZONE 2 key to select the Group 2.
The ZONE 2 indicator will slowly flash* to indicate that Group 2 was selected.
Pressing other selector key will change the group number
Step 3. Group number programming
Press the POWER switch.
The Group 2 will be programmed and the unit will be placed in Zone Selection mode for Group 2.
•The ZONE 2 indicator changes from "quick flashing" to "slow flashing*," indicating that Group 2 was selected and that Zone 2 was set (default setting).
•The remaining indicators, ZONE 1, ZONE 3, ZONE 4, ZONE 5, and ALL flash. (This indicates that Zones 2 was set as default.)
ZONE 1 | ZONE 2 | Reset |
Group 1 | Group 5 |
ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 | ALL |
Group 1 | Group 5 |
ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 | ALL |
Zone 1 |
| Group 2 |
| Zone 5 | ||||||||
|
|
|
|
| (Zone 2) |
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 | ALL |
53
