TOA Electronics VM-2120 instruction manual All zones setting and its cancellation

Step 4. Zone number setting (Example: Zones 2, 3, and 4)

Press the ZONE 3 and ZONE 4 keys to select the corresponding zones. (As a result, The Zones 2, 3, and 4 are selected.)

•Indicators for ZONE 3 and ZONE 4 will light.

(This represents that Zones 3 and 4 were selected.)

•Indicators for ZONE 1 and ZONE 5 will flash.

(This represents that Zones 1 and 5 are not selected.)

•The ZONE 2 indicator remains "slow flashing*." (This represents that Group 2 has already been selected, and that Zone 2 is currently selected as default setting.)

Zone 1	Group 2	Zone 5
	(Zone 2)

ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 ALL

Note: For "All zones" settings in this step, refer to the section "All zones setting and its cancellation" below.

Step 5. Programming of the zone number setting

Press the POWER switch.

POWER

The Zones 2, 3, and 4 will then be programmed, automatically returning the procedure to Step 2. According to the instructions in Step 2, set the next zone group. (Repeat Steps 2 through 5.)

Step 6. Group setting completion
After completing all group settings, press the Reset key	Reset
using a pointed object.

This completes the setting mode, returning the unit to broadcast standby mode.

* See p. 55 Indicator status.

[All zones setting and its cancellation]

Pressing the ALL key selects all zones and places the unit in the external attenuator bypass mode. The ALL indicator and the indicators for ZONE 1 and ZONE 3 – ZONE 5 will light, while the ZONE 2 indicator will slowly flash.

Zone 1	Group 2	Zone 5
	(Zone 2)

ZONE 1	ZONE 2 ZONE 3 ZONE 4		ZONE 5 ALL
Zone 1		Group 2	Zone 5
When the ALL indicator is steadily on, if the ALL key is pressed,		(Zone 2)
the selection of all zones will be cancelled. Then, the setting
returns to the situation before the "ALL zones" was set.

ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 ALL

54