Toshiba B-SX4T owner manual Appendix 1 Messages and Leds, Symbols in the message

APPENDIX 1 MESSAGES AND LEDS

ENGLISH VERSION EO1-33058

APPENDIX 1 MESSAGES AND LEDS

APPENDIX 1 MESSAGES AND LEDS

Appendix 1 describes the LCD messages displayed on the operation panel.

Symbols in the message

1:: The LED is illuminated. ~: The LED is flashing. z: The LED is unlit.

2:****: the number of unprinted media. Up to 9999 (in pieces)

3:%%%%%%%: ATA Card’s remaining memory 0 to 9999999 (in K bytes)

4:###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)

5:&&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)

		LED Indication		Restoration by	Acceptance of
No.	LCD Message		Printer Status	RESTART key	Status Request
		POWER ONLINE ERROR		Yes/No	Reset Command
					Yes/No

1	ON LINE				z	In online mode	-----	Yes
	ON LINE			~	z	In online mode (The printer in	-----	Yes
						communication)
2	HEAD OPEN			z	z	The print head block is opened in online	-----	Yes
						mode.
3	PAUSE ****			z	z	The printer is paused.	Yes	Yes
						A parity, overrun, or framing error has	Yes	Yes
4	COMMS ERROR			z		occurred during communication through
						the RS-232C.
5	PAPER JAM	****		z		The media is jammed during paper feed.	Yes	Yes
6	CUTTER ERROR****			z		A problem has occurred with the cutter	Yes	Yes
						module.
7	NO PAPER	****		z		The media has run out, or the media is	Yes	Yes
						not loaded properly.
8	NO RIBBON	****		z		The ribbon has run out.	Yes	Yes
9	HEAD OPEN	****		z		Feed or printing was attempted with the	Yes	Yes
						print head block open.
10	HEAD ERROR			z		There is a problem with the print head.	Yes	Yes
11	EXCESS HEAD TEMP			z		The print head is overheated.	No	Yes
						The ribbon has been torn. A problem	Yes	Yes
12	RIBBON ERROR****			z		has occurred with the sensor that
						determines the torque for the ribbon
						motor.
13	REWIND FULL ****			z		An overflow error has occurred in the	Yes	Yes
						rewinder unit.
	SAVING%%%%%%%					In writable character or PC command	-----	Yes
14	or				z	save mode
	SAVING ###&&&&
15	FLASH WRITE ERR.			z		An error has occurred while writing to	No	Yes
						flash memory or ATA card.
						An erase error has occurred in	No	Yes
16	FORMAT ERROR			z		formatting the flash memory or ATA
						card.
17	FLASH CARD FULL			z		Data cannot be stored because the flash	No	Yes
						memory or ATA card is full.
18	Display of error			z		A command error has occurred in	Yes	Yes
	message (See Notes.)					analyzing the command.
19	POWER FAILURE			z		A power failure has occurred.	No	No
20	INTIALIZING…			z	z	A flash memory card is being initialised.	-----	-----
21	EEPROM ERROR			z		Data cannot be read from/written to a	-----	-----
						backup EEPROM properly.

EA1- 1