Toshiba B-SX4T owner manual Batch mode, Strip mode Option, STANDARD/PEEL OFF position

2. PRINTER SETUP

ENGLISH VERSION EO1-33058

2.4 Loading the Media

2.4Loading the Media (Cont.)

12.There are four issue modes available on this printer. How to set the media for each mode is provided below.

Batch mode

In the batch mode, the media is continuously printed and fed until the number of labels/tags specified in the issue command have been printed.

NOTES:

1.Be sure to set the Selection Switch to STANDARD/ PEEL OFF position.

2.The backing paper is easier to feed back to the Take-Up Spool if the Front Plate is removed.

3.Fit the Take-Up Clip so that the longer side of the clip is fitted into the shallow groove in the Take-Up Spool.

4.The backing paper can be wound directly onto the Take- up Spool or a paper core. When using the Take-up Spool, detach the Holder Stopper by removing the B- 3x4 screw. Otherwise, it may be difficult to pull out the wound backing paper roll.

Holder Stopper

B-3x4 Screw

Take-up Spool

Take-up Clip

When using a paper core, put the core on the Take-up Spool with the Holder Stopper on it, and attach the top edge of the backing paper to the core with adhesive tape. The Take-up Clip is not necessary.

This winding method is applicable to the Built-in Rewinder mode.

Strip mode (Option)

When the optional Strip Module is fitted, the backing paper is automatically removed from the label at the Strip Plate as each label is printed.

(1)Remove enough labels from the leading edge of the media to leave 500mm of backing paper free.

(2)Insert the backing paper under the Strip Plate.

(3)Wind the backing paper onto the Take-up Spool and fix it in position with the Take-up Clip. (Wind the paper counterclockwise around the spool as this is the direction it rotates.)

(4)Rotate the Take-up Spool anti-clockwise a few times to remove any slack in the backing paper.

(5)Set the Selection Switch mounted on the Rewinder Assembly to

STANDARD/PEEL OFF position.

Take-up Spool

Front Plate

Take-up Clip

Black Screw Strip Plate Backing Paper

E2- 7