Toshiba B-SX4T owner manual Supply Specifications, Media Type

7. SUPPLY SPECIFICATIONS

ENGLISH VERSION EO1-33058

7.1 Media

7. SUPPLY SPECIFICATIONS

7.1 Media

Please make sure that the media being used is approved by TOSHIBA TEC. The warranty does not apply when a problem is caused by using media that is not approved by TOSHIBA TEC.

For information regarding TOSHIBA TEC approved media, please contact a TOSHIBA TEC authorised service representative.

7.1.1 Media Type

Two types of media can be loaded for this thermal transfer and direct thermal printer: label or tag. The table below shows size and shape of the media available for this printer.

	Black Mark		Black Mark
Label	(on reverse side) Refer to	Tag paper	(on reverse side)
	NOTE 3 below.

Stop position k

Cut position

j

i f e

Stop
position k
h g	h
Cut position
c	c
d
	i
Feed Direction	e
	[Unit: mm]

	Label dispensing mode	Batch mode	Strip mode	Cut mode
Item				Rotary cutter (*2)	Swing cutter
c Media pitch	Label	10.0 – 1500.0	25.4 – 1500.0	3”/sec., 6”/sec.: 38.0 - 1500.0	38.0 – 1500.0
	Tag	10.0 – 1500.0	----	3”/sec., 6”/sec.: 30.0 – 1500.0	25.4 – 1500.0
d Label length		8.0 – 1498.0	23.4 – 1498.0	3”/sec., 6”/sec.: 32.0 – 1494.0	25.0 – 1494.0(*1)

e Width including backing paper (See NOTE 5.)		30.0 – 112.0	50.0 – 112.0	30.0 – 112.0
f Label width (See NOTE 5.)		27.0 – 109.0	47.0 – 109.0	27.0 – 109.0
g Gap length		2.0 – 20.0		6.0 – 20.0
h Black mark length (Tag paper)				2.0 – 10.0
i Effective print width				10.0 – 104.0
j Effective print length	Label	6.0 – 1496.0	21.4 – 1496.0	3”/sec., 6”/sec.: 30.0 – 1492.0	23.0 – 1492.0
	Tag	8.0 – 1498.0	----	3”/sec., 6”/sec.: 28.0 – 1496.0	23.0 – 1496.0
k Print speed up/slow down area				1.0
Thickness	Label			0.13 – 0.17
	Tag			0.15 – 0.29
Maximum effective length for on the fly issue				1361.0
Maximum outer roll diameter				Ø200
Roll direction				Inside
Inner core diameter				Ø76.2±0.3

E7- 1