Toshiba B-SX4T owner manual Parameter Setting Cont, Auto Print Head Check Selection

2. PRINTER SETUP

ENGLISH VERSION EO1-33058

2.9 Setting an Operating Environment

2.9.1Parameter Setting (Cont.)

NOTES:

1.It takes about 2 seconds to perform an Auto Print Head check.

2.It is recommended that this function should be activated when high quality printing such as bar codes printing is required. Otherwise, choose OFF.

3.When a broken element is found, the printer stops, displaying “HEAD ERROR”. The error state can be cleared by pressing the [RESTART] key, but if the broken element affects bar code readability or actual operations, please replace the print head with a proper one.

(18) Auto Print Head Check Selection

This parameter is to choose whether to perform the Auto Print Head Check function at the power on time. When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET AUTO HD CHK OFF

Use the [FEED] or [RESTART] key to select a desired option.

		AUTO HD CHK OFF
[RESTART]
		Auto print head broken element
		check is not performed.
	[FEED]
		AUTO HD CHK ON

Auto print head broken element check is performed.

After selecting auto print head check, press the [PAUSE] key.

(19) Centronics Interface ACK/BUSY Timing Selection

This parameter is to choose an ACK/BUSY timing of the Centronics interface.

“TYPE1” has been chosen as default, but if a communication error occurs or a communication is not properly made, change to “TYPE2”.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears”.

<2>PARAMETER SET ACK/BUSY TYPE1

Use the [FEED] or [RESTART] key to select a desired option.

		ACK/BUSY TYPE1
[RESTART]			and a release of
		A rise of ACK signal
		BUSY occur at the same time.
	[FEED]
		ACK/BUSY TYPE2

A fall of ACK signal and a release of

BUSY occur at the same time.

After selecting an ACK/BUSY timing, press the [PAUSE] key.

E2-25