Toshiba B-SX4T owner manual Label End/Ribbon End Selection, Pre-Strip Selection

2. PRINTER SETUP

ENGLISH VERSION EO1-33058

2.9 Setting an Operating Environment

2.9.1Parameter Setting (Cont.)

(26) Label End/Ribbon End Selection

This parameter is to choose a printing process when a label end or ribbon end is detected.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET LBL/RBN END TYP1

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

[FEED]

LBL/RBN END TYP1

TYPE1: When a label/ribbon end is detected in the middle of printing, printing is immediately paused.

LBL/RBN END TYP2

TYPE2: When a label/ribbon end is detected in the middle of printing, the printer prints the half-finished label as far as possible, and stops when the next label is at the home position.

NOTE:

When the print speed is set to 10”/sec., the pre-strip function will be activated regardless of this parameter setting.

After selecting a Label End/Ribbon End type, press the [PAUSE] key.

(27) Pre-Strip Selection

This parameter is to choose whether to activate the Pre-strip function. When this parameter is set to ON (Available), the top edge of a label is separated (pre-stripped) from the backing paper before the label is printed. This function is intended to make the strip issue easier in case the labels are hard to strip due to the label intensity, adhesive power, or the printing speed.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET PRE PEEL OFF OFF

Use the [FEED] or [RESTART] key to select a desired option.

			Unavailable
[RESTART]		PRE PEEL OFF OFF
	[FEED]
		PRE PEEL OFF ON	Available

After selecting the Pre-strip function, press the [PAUSE] key.

E2-29