Toshiba B-SX4T owner manual Built-in rewinder mode Option, Cut mode Option

2. PRINTER SETUP

ENGLISH VERSION EO1-33058

2.4 Loading the Media

2.4Loading the Media (Cont.)

NOTE:

Be sure to set the Selection Switch to REWINDER position.

ADJUSTMENT:

If the media skews when using the Built-in Rewinder, turn the Adjustment Knob of the Rewinder Guide Plate to correct the media feed. Clockwise turn moves the Rewinder Guide Plate forward and counter-clockwise moves it backward.

When the media skews to the right: Loosen the SM-4x8 screw, turn the Adjustment Knob clockwise, and then tighten the SM-4x8 screw when the Rewinder Guide Plate is positioned correctly.

When the media skews to the left: Loosen the SM-4x8 screw, turn the Adjustment Knob counter-clockwise, and tighten the SM-4x8 screw when the Rewinder Guide Plate is positioned correctly.

WARNING!

The cutter is sharp, so care must be taken not to injure yourself when handling the cutter.

CAUTION!

1.Be sure to cut the backing paper of the label. Cutting labels will cause the glue to stick to the cutter which may affect the cutter quality and shorten the cutter life.

2.Use of tag paper when the thickness exceeds the specified value may affect the cutter life.

NOTE:

When using the Rotary Cutter, be sure to install the Ribbon Saving Module (B-9904-R2-QM-R).

Failure to do this may cause a paper jam or ribbon error.

Built-in rewinder mode (Option)

The Rewinder Assembly of the Strip Module can be used in batch mode to take up the printed media as a Built-in Rewinder.

(1)Remove the two Black Screws to detach the Front Plate.

(2)Attach the Rewinder Guide Plate enclosed with the optional Strip Module to the Strip Plate with the SMW-4x8 sems screws.

(3)Insert the media under the Rewinder Guide Plate.

(4)Wind the media onto the Take-up Spool and fix it in position with the Take-up Clip.

(5)Rotate the Take-up Spool counterclockwise a few times to remove any slack in the media.

(6)Set the Selection Switch mounted on the Rewinder Assembly to REWINDER position.

SMW-4x8 Screw

Rewinder

Guide Plate

Adjustment Knob

SM-4x8 Screw

Cut mode (Option)

When the optional Cutter Module is fitted, the media is automatically cut. A swing cutter and a rotary cutter are available as an option, but they are used in the same way.

Insert the leading edge of the media into the Media Outlet of the Cutter Module.

Cutter Module

Media

Media Outlet

13.If the loaded media is direct thermal media (a chemically treated surface), the media loading procedure is now completed. Close the Ribbon Shaft Holder Plate, and turn the Head Lever to Lock position to close. Then, close the Top Cover.

If the media is thermal transfer media, it is also necessary to load a ribbon. Refer to Section 2.5 Loading the Ribbon.

E2- 8