![](/images/new-backgrounds/1184355/184355281x1.webp)
Optional Devices
i.LINK (IEEE1394)
i.LINK (IEEE1394) is used for
■Digital video cameras
■Hard disk drives
■MO drives
■Optical disc drives
i.LINK uses a
Precautions
■Make a
■Do not transfer data in areas where static electricity is easily generated or in areas subjected to electronic noise. Data can be destroyed.
■If you are transferring data through an IEEE1394 hub, do not connect or disconnect other devices from the hub during data transfer. There is a likelihood that data will be damaged. Connect all devices to the hub before you turn on the computer's power.
Connecting
1.Make sure the connectors are properly aligned and plug the i.LINK (IEEE1394) cable into the computer.
2.Plug the other end of the cable into the device.
Note the following when you use i.LINK:
■You may need to install drivers for your i.LINK devices.
■Not all i.LINK devices have been tested. Therefore, compatibility with all i.LINK devices cannot be guaranteed.
■Use S100, S200 or S400 cables no longer than three meters.
■Some devices might not support standby or automatic off functions.
■Do not connect or disconnect an i.LINK device while it is using an application or when the computer is automatically shutting it down to save power. Data might be destroyed.
Disconnecting
1.Click the Safely Remove Hardware icon on the Task Bar.
2.Point to i.LINK (IEEE1394) device and click.
3.Disconnect the cable from the computer then from the i.LINK device.
Refer also to the documentation that came with your i.LINK device.
TOSHIBA M50 |