
Troubleshooting
Standby/Hibernation
| Problem | Procedure |
|
|
|
| The system will not | Is Windows® Media Player open? The system |
| enter Standby/ | might not enter Standby/Hibernation, if |
| Hibernation | Windows® Media Player is either playing a |
|
| selection or finished playing a selection. Close |
|
| Windows® Media Player before you select |
|
| Standby/Hibernation. |
|
| If problems persist, contact your dealer. |
|
|
|
Real Time Clock |
| |
|
|
|
| Problem | Procedure |
|
|
|
The following message is displayed on the LCD:
RTC battery is low or CMOS checksum is inconsistent. Press [F2] key to set Date/ Time.
The RTC battery charge has become exhausted, you should set the date and time in within the BIOS setup screen through the following steps:
1.Press [F1] key. BIOS setup will boot up.
2.Press [F2] to set the date in [System Date].
3.Press [F2] to set the time in [System Time].
Memory expansion
Refer also to Chapter 8, Optional Devices, for information on installing memory modules.
Problem | Procedure | ||
|
| ||
The computer hangs up | Make sure the memory module installed in the | ||
and issues beep | expansion slot is compatible with the computer. | ||
sounds. (A long leep, | If an incompatible module has been installed, | ||
three short beeps, three | |||
follow the steps below. | |||
short beeps, and then a | 1. | Turn off the power. | |
long beep.) | 2. | Disconnect the AC adapter and all peripheral | |
| |||
|
| devices. | |
| 3. | Remove the battery pack. | |
| 4. | Remove the memory module. | |
| 5. | Replace the battery pack and/or connect the | |
|
| AC adapter. | |
| 6. | Turn on the power. | |
| If problems persist, contact your dealer. | ||
|
|
|
TOSHIBA M50 |