Toshiba MA-1595-1 Series PLU Preset-Code Key Setting Submode, Barcode Scanning PLU Code KEY

6. PROGRAMMING OPERATIONS EO1-11152

6.14 PLU Preset-Code Key Setting (Submode 27)

6.14PLU Preset-Code Key Setting (Submode 27)

When there are any keys programmed as PLU Preset-code Keys on the ECR Keyboard (Ordinary or Flat Type), and/or when the PLU Keyboard PK-2 (hardware option) is connected to the ECR, a PLU code may be preset to each of those keys in this operation.

CONDITION	Any time outside a sale
OPERATION	Mode Lock: SET
	Repeat for other keys.

27[X]

Barcode Scanning

PLU Code [KEY]

[AT/TL]

Enter through Numeric Keys on the ECR Keyboard (Enter 0 to close the key); Max. 6 or 13 digits

Depress the required key on the ECR keyboard or on the PK-2 keyboard.

NOTES: 1. If the PLU Code entry is skipped and a [KEY] is simply depressed in the above sequence, the preprogrammed PLU Code of the KEY will be displayed.

2.A non-opened PLU Code (i.e. PLU non-existent in the PLU table file) can be set on a KEY;

however, pressing the KEY in sale entries will result in an error unless the code is opened in the
	Mode Lock to SET	&ORVHG2SHQ7(&6725(￿￿￿￿3+21(￿￿￿HYHU\3(￿$DP￿￿￿￿￿&+WR:HGQHVGD\'5,9(￿￿￿￿SP
PLU TABLE PROGRAMMING operation, Submode 4.
3. If “0” is entered as PLU Code in the above sequence, the KEY will be closed. Pressing the closed
KEY in sale entry will cause an error.
Example) To set following PLU Codes to KEYs on the ECR keyboard:
	27 [X]
		￿￿￿￿￿￿￿￿￿￿￿	￿￿￿3021￿￿￿￿
PLU Code	[AT/TL]
50321	50321 [required key]
50322	50322 [required key]
Location Code (left side); refer to REMARKS 1 and 2 on the next page.			￿￿￿￿￿￿￿￿￿70
PLU code assigned to the key (right side)

6-32