7. VERIFICATION OF PROGRAMMED DATA

EO1-11152

7. VERIFICATION OF PROGRAMMED DATA

7. VERIFICATION OF PROGRAMMED DATA

The programmed data entered in the preceding chapter can be read for verification purposes.

The print format of each program reading is almost the same as on the program receipt, except that “PX” and a 3-digit number are printed instead of printing “P” and a 2-digit number.

CONDITION

Any time outside a sale

OPERATION

Mode Lock: X or SET

1.To read out the data of programming operations with a Submode No., first enter “1,” then each Submode No., and finally depress the [AT/TL] key.

For example, to read the programmed data entered in Submode 1 (STORE NAME/MESSAGE, COMMERCIAL MESSAGE, PROGRAMMING), operate:

1 0 1 [AT/TL]

Submode No. (In case of a 1-digit number, add a “0” on top to be a 2-digit number.

Always attach “1” to the Program Submode No. for reading data.

NOTE: Data of Submodes 5, 6 cannot be read.

2.To read out the data of programming operations without a Submode No., the following operation will read all the data together:

1 0 0 [AT/TL]

To read the data of the following operations:

%+ and %- PRESET RATE

SELECTIVE ITEMIZER RATE

FOREIGN CURRENCY EXCHANGE RATE

TAX TABLE (For tax calculation test, refer to the next page.)

3. Zone destination is possible in reading the PLU TABLE:

104

 

[ST]

 

 

Zone-start

[@/FOR]

Zone-end

 

 

 

 

 

 

 

PLU Code

 

PLU Code

 

 

 

 

 

 

 

 

[AT/TL]

NOTE: On depressing the [AT/TL] key, the programmed data will be printed. To abort printing once started, depress the [ITEM CORR] or [VOID] key. The reading operation is immediately stopped halfway.

7- 1

Page 165
Image 165
Toshiba MA-1595-1 Series owner manual Verification of Programmed Data, 1 AT/TL, 0 AT/TL