Toshiba PROA660 - page 188

4 Replacement Procedures

Satellite A660/ProA660 Series Maintenance Manual 4-13

5. Remove the four M3x3 screws with torque value 3.5kgf in order as indicated in Figure

4.5 and separate the HDD foil from the HDD.

NOTE: The HDD foil screws on this module are specific to the system. Screws from older

systems are not compatible and must not be used on the HDD.

Figure 4.5 Removing the HDD foil

CAUTION: Do not apply pressure to the top or bottom of the drive.

Installing the HDD

Install the HDD according to the following procedures and Figure 4.6.

CAUTION: To avoid damage, always hold the HDD only by its sides.

1. Place the HDD foil on the HDD.

2. Secure the HDD foil with four M3x3 screws in order as indicated in Figure 4.6.

NOTE: The HDD foil screws on this module have oversized heads and are specific to the

system. Screws from older systems are not compatible and must not be used on the HDD.

M3x3*2