When you use the air conditioner for the first time or when you change the SET DATA value, follow the proce- dure below. From the next time, the operation displayed on the remote controller will start by pushing the button only.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
*After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute, but it is not a failure.
•While using the air conditioner, operate it only with button without turning off the main power switch and the leak breaker.
3
UNIT
SET CL
1 Push | button. |
1
2
4
The operation lamp goes on, and the operation starts.
One push of the button, and the display changes in the order shown on the right.
AUTO HEAT DRY COOL FAN
•In HEAT mode, if the room temperature reaches to the set temperature, the outdoor unit stops and the air flow becomes LOW and the air volume decreases.
•In the defrost mode, the fan stops so that cool air is not discharged and
One push of the button, and the display changes in the order shown on the right.
AUTO HIGH MED. LOW
•When air volume is “AUTO ”, air volume differs according to the room temperature.
•In DRY mode, “AUTO ” is displayed and the air volume is LOW.
•In heating operation, if the room temperature is not heated sufficiently with VOLUME “LOW ” opera- tion, select “MED. ” or “HIGH ” operation.
4 Determine the set up temperature by pushing the “TEMP. ” or “TEMP. ” button.
20