PARTS NAME OF REMOTE CONTROLLER
Display section
All display items are shown in right figure for the explanation.
Only selected contents are displayed in actual operation.
•When turning on the leakage breaker at the first time, [SET DATA] flashes on the display part of the remote controller. While this display is flashing, the model is being automatically confirmed. Accordingly, wait for a while after [SET DATA] display has disap- peared, and then use the remote controller.
SET DATA
SETTING
SET
CODE No.
UNIT No.
TEST R.C. No.
UNIT
CL
Display section
Operation section
1 9
2 | 3 |
|
|
| |
4 | SET DATA |
|
| ||
|
|
| |||
|
|
| UNIT No. | ||
5 | SETTING | TEST | R.C. No. | ||
6 | |||||
| |||||
7 |
|
|
| ||
|
|
|
| ||
8 |
|
|
|
|
CODE No.
10
11
12
1314
1516
1 SET DATA display
Displayed during setup a timer.
The selected operation mode is displayed.
3 CHECK display
Displayed while the protective device works or a trouble occurs.
4 Timer time display
Set time by the timer is displayed.
(When a trouble occurs, the check code is displayed.)
Displayed during up/down movement of the flap.
The selected set up temp. is displayed.
Displayed while the sensor of the remote controller is working.
Displayed when the heating operation starts or defrost operation is carried out.
5
6
7
8
9
When pushing the Timer SET button, the display of the timer is selected in order of
[OFF] → [OFF] repeat OFF timer
→[ON]
→ No display.
If “FILTER ” is displayed, clean the air filter.
Ventilator operation display
While this indication is displayed, the indoor fan stops or the mode changes in LOW.
Displayed if there is no function even if the button is pushed.
The selected fan mode is displayed. (AUTO)
(HIGH) (MED.) (LOW)
Displayed during a test run.
52