(1)Operate the fan for 3 to 4 hours to dry inside the unit
• Operate “FAN ONLY” mode with set temperature 30°C.
(2)Stop the air conditioner and turn off the main power switch or the circuit breaker.
(1)Check that the air filters are installed.
(2)Check that the air outlet or inlet is not blocked.
(3)Turn on the main power switch or the circuit breaker for the mains AC outlet to turn on the air conditioner.
WARNING
Make sure to ask the qualified maintenance professional for cleaning.
Turn off the main power supply switch or breaker before the unit maintenance.
• | If | is displayed on the remote controller, maintain the air filter. |
• | Clogging of the air filter reduce cooling/heating performance. |
Cleaning of panel and air filter | Suction grille |
| |
Preparation : |
|
1. Turn off the air conditioner by the remote controller.
2. Open the suction air port. | Button |
|
•Slide the button of the suction air port inward, and open the suction port slowly while holding it.
•Wipe down the panel and air filter with a sponge or towel moistened with a kitchen detergent. (Do not use any metallic brush for cleaning.)
• After rinsing the panel and air filter with water, dry it in the shade. | Suction grille |
|
3. Close the suction air port.
• Close the suction air port, slide the button outward, and fix the suction port securely.
CAUTION
•Do not start the air conditioner while leaving the panel and air filter removed.
•Push the filter reset button. ( indication will be turn off.)
Button
•Recommended cleaning intervals: Every two weeks.
•If the air filters are not cleaned, it not only reduce the cooling a performance of air conditioner but causes a failure in the air conditioner such as water falling in drops.
Preparation :
1.Stop the operation by remote controller.
2.Dismount the air filter.
Strap to prevent falling
Air filter
Push
25