In the display example, all indicators are displayed for the explana- tion.
In reality only, the selected contents are indicated.
•When turning on the leak breaker at the first time, [SET DATA] flashes on the display part of the remote controller. While this display is flashing, the model is being automatically confirmed. Accordingly, wait for a while after [SET DATA] display has disappeared, and then use the remote controller.
CODE No.
SET DATA
UNIT No.
SETTINGTEST R.C. No.
UNIT
SET CL
Display section
Operation section
|
| 1 8 |
|
|
|
2 |
|
|
| CODE No. | 9 |
| 3 |
|
|
| |
4 | SET DATA |
| 10 |
| |
|
|
|
| ||
|
| UNIT No. |
|
| |
5 | SETTINGTEST | R.C. No. |
| 11 | |
| 12 | ||||
|
|
| |||
| 6 |
|
| 13 | |
7 |
|
|
| 14 |
|
Displayed during setup of the timer.
The selected operation mode is displayed.
Displayed while the protective device works or a trouble occurs.
Time of the timer is displayed.
(When a trouble occurs, the check code is dis- played.)
When pushing the Timer SETIN button, the display of the timer is selected in order of [OFF]
→ | [OFF] repeat OFF timer → [ON] |
→ | No display. |
If “FILTER ” is displayed, clean the air filter.
Displays flap position.
Displayed during up/down movement of the flap.
The selected set up temp. is displayed.
Displayed while the sensor of the remote controller is used.
Displayed when the heating operation starts or defrost operation is carried out.
While this indication is displayed, the indoor fan stops or the mode enters in LOW.
Displayed if there is no function even if the button is pushed.
The selected air volume mode is dis- played.
(AUTO) (HIGH) (MED.)
(LOW)
18