Cabling
1.Remove a screw and then remove cover of the electric parts box.
2.Strip wire ends (10 mm).
3.Match wire colors with terminal numbers on indoor and outdoor units’ terminal blocks and firmly screw wires to the corresponding terminals.
4.Connect the ground wires to the corresponding terminals.
5.Fix the cable with cord clamp.
6.Fix cover of the parts box and the terminal block surely with the fixing screws.
Make a loop on the cable for margin of the length so that the electric parts box can be taken out during servicing.
10 | 1 | 2 | 3 |
|
|
| 10 |
40 |
|
| 30 |
|
|
|
Earth line
Connecting cable
Cabling diagram
Terminal block |
|
|
|
|
|
|
|
|
for remote controller | Approx. 200mm | W : White | ||||||
cabling of indoor unit |
|
|
|
|
|
|
| B : Black |
|
|
|
|
|
|
| ||
A |
|
| W |
|
|
|
| |
|
|
|
|
|
| Remote | ||
|
|
|
|
|
| |||
B |
|
| B |
|
|
|
| controller unit |
|
|
|
|
|
|
|
| or sensor part |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
Remote controller cable | Connecting | Remote controller unit or | ||||||
(Local procure) | part | cable from sensor part | ||||||
Remote controller cabling
Cable from remote | Wire joint |
controller unit |
Remote controller
Remote controller
cable
A B
Indoor side
1 2 3
Indoor/Outdoor connecting cable
1 2 3
Outdoor side
L N
(Single phase 220/230/240V)
•For details of cabling/installation of the remote controller, refer to the Installation Manual attached to in the remote controller.
Remote Controller Cabling
•Strip off approx. 14mm the cable to be connected.
•Non polarity, 2 core cable is used for cabling of the remote controller.
•Twist cable of the remote controller to be connected with cable of the remote controller unit (or sensor), and
Wire joints (White: 2 pieces) are included in the attachments to the remote controller (sold separately) or the wireless remote controller kit (sold separately).
46
